Custom LEDE image for Banana Pi R1 with OpenVPN
You could easily make it yourself. You can download it here. It's version 17.01. The packages included: adblock - 2.4.0-2 base-files - 172-r3205-59508e3 bus...
You could easily make it yourself. You can download it here. It's version 17.01. The packages included: adblock - 2.4.0-2 base-files - 172-r3205-59508e3 bus...
The solution is simple, reinstall adblock. Assuming you are using a Banana Pi R1. opkg install http://downloads.openwrt.org/snapshots/trunk/sunxi/generic/pa...
[ ID] Interval Transfer Bandwidth Retr Cwnd[ 4] 0.00-1.00 sec 82.8 MBytes 695 Mbits/sec 0 211 KBytes [ 4] 1.00-2....
According to this forum post, somebody uses two USB cables to boot android. I'll plug another one in and see if sensors changes. That's cheaper/easier then b...
The easiest solution is to buy a Barrel Jack to 2-pin JST and then a Wall Adapter Power Supply - 5V DC 2A (Barrel Jack) or Barrel Jack Adapter - USB to 5.5mm...
Making a copy of my micro SD card using dd. Restoring just one partition doesn't work, says over 600 mb/s. The old card is 8 GB. So it'll take a while to wri...
It has two micro USB slots, if you plug it into the wrong one, it won't turn on. Will it be faster if it has two power sources? Or will it be fried? To risky...
Looks like the USB cable my Banana Pi R1 came with is crap, and so are my Anker USB cables. I get 16.72 Mbps download on my phone now, it was under 10 Mbps b...
Taking a dump at 10 PM. I can connect to the wifi but nothing loads then my phone disconnects. Does the wifi on my new router suck or is the power adapter cr...
Since I redid the micro SD card and restored my backup, OpenVPN no longer works. It connects and tun0 exists, but the traffic doesn't use it. According to te...
Search Google for that, and you'll find nothing. So now I'll search Google for how to make a startup script that will mount it for me. /etc/config/fstab conf...
That happens if you reboot it by unplugging the router. I did fsck on it, and tried rebooting, but it wasn't turning back on or something. So I took the micr...
I put the sides back on, still can't screw one part in. It isn't pushed down on one end. Not moving it, so I don't care. To lazy to try and fix it. Most o...
Did one of the antennas come unhooked from my Banana Pi R1? I just made one of the antennas more secure. But the adapter could be unhooked from the board. Do...
Looks like my Banana Pi R1 can't give me 20 Mbps if I use OpenVPN. I should try it in Ubuntu, then I'd know if it's OpenVPN, or the router. I like the clear ...
My Banana Pi R1 works. It has two micro USB connections, I had it plugged into the second one. Don't know if it'll boot from the hard drive, I think I tried ...
Doesn't appear to boot from a SATA disk. I took the micro SD card out of my tablet, and am writing OpenWrt to it. Sucks it can't boot from SATA. I broke part...
I'd get the ODROID, it's cheaper. And has USB 3.0. The SATA on the M3 is by USB, so probably only USB 2.0 speeds.
Would that be overkill for a router? Doesn't have a bunch of ethernet jacks like the one meant to be a router, but it has a Octa core processor. Make it a Op...
Don't think I've ever used pfSense. There's an ARM version of IPFire, probably won't work on the Banana Pi though. It might work if you are smart enough, you...